Transmission Test Opwill OTM2502

• OTM2502 (not support OTN) and OTM2512 10G multi service test modules are the comprehensive test solution provided by OPWILL, for 1.5M to 10G full rate PDH, SDH, OTN, and IP RAN/PTN network test. It specialised for mobile backhaul network performance measurement. OTM2502 can be upgraded to OTM2512.This module is compatible with OTP6200v2 (OPWILL Intelligent Network Test Platform).

Highlights

• All-in-one test instruments support with OTN, EoS, SDH, SONET, PDH, DSn, MPLS-TP and Ethernet;
• Advanced differential delay measurement, generation, and payload reassembly;
• Ethernet traffic generation over SDH/SONET without extra equipment; 
• Ethernet testing up to 10Gbps including RFC2544, RFC3393 and Y.1564;
• MPLS-TP up to 10Gbps.

Applications

• Out-of-Service Test:
• End-to-End error free transmission verification;
• Automatic Protection Switching verification;
• SDH/SONET mapping verification down to VC12/VT1.5;
• Round Trip Delay;
• In-Service Test:
• Through mode;
• In-Service monitoring protected monitoring points or optical splitters;
• Overhead bytes monitoring and decoding;
• Pointer monitoring;
• Carrier Ethernet Installation and Troubleshooting:
• Ethernet traffic generation up to 10G;
• Metro/Carrier test up to 10G including RFC2544, Y.1654;
• MPLS-TP test up to 10G;
• Packet capture for advanced troubleshooting.

Key Features

• OTN:
• Complies ITU-T G.709, and G.sup43;
• OTU1, OTU2, OTU1e, and OTU2e interfaces;
• Synchronous/asynchronous mapping of SDH/SONET signals;
• OTU, ODU, OPU error injection and alarm generation;
• OTU, ODU, OPU bytes control and decode;
• APS Time measurement;
• SDH/SONET:
• STM-1/ STM-4/ STM-16/ STM-64, and OC-3/ OC-12/ OC-48/ OC-192 interfaces;
• Mapping/de-mapping of payloads from VC4-64c/STS-192c down to VC11/VC12, and VC1.5/VT2;
• SDH/SONET overhead control and decode;
• Pointer monitoring and adjustment, G.783 pointer test sequences generation;
• APS time measurement;
• PDH/DSn:
• DS1/DS3, E1/E3/E4 interfaces;
• APS time measurement;
• Error performance analysis per ITU-T G.821, G.826, and M.2100;
• Ethernet:
• 10/100/1000M Base-T, 100M-FX, 1000M Base-X, 10G Base-X interfaces;
• Generate up to 16 traffic flows with different MAC address, VLAN tags, MPLS, IP address, TCP/UDP, payload and bandwidth;
• MPLS-TP test up to 10G;
• Perform throughput, latency, frame loss, and back-to-back measurements per industry-standard RFC2544;
• Network configuration test and performance test per standard ITU-T Y.1564;
• Service disruption test.