Description
Kikusui Fuel Cell Impedance Meter KFM2005 is designed to test fuel cells with small currents (5 A or less), and not only test the voltage and current characteristic, the KFM2005 can easily measure the impedance of the battery. fuel using the AC impedance method, and Cole-Cole plot: Using the measurement data of the Cole-cole plot, the circuit constant of the approximate equivalent circuit of the fuel cell can be calculated. The built-in DC load (60W) is capable of operating from 0 V and it can perform fuel cell testing up to 20V and 5A.
Features
- Impedance of cells up to 20V can be measured in the range of 10 mHz to 10 kHz.
(The cell voltage/current can be read back as well in the 0 V to 20 V / 0 A to 5 A range.) - Impedance measurement.
(The measurement AC current can be set for the range at 10% to 100% of each range of the rated value in 0.1% step. )
(Impedance measurement under condition of measurement AC voltage at 5 mV applied by the dummy constant voltage can also be set. ) - Built-in electronic load offers two constant current modes ranges for the load rating: 5 A and 0.5 A Load current setting resolutions of 0.1 mA (5 A range) and 0.01 mA (0.5 A range), with maximum power consumption of 60 W.
- Equipped with “Undervoltage protection”, “Overvoltage protection”, “Overpower protection”, “Overheat protection”, “Overcurrent protection”, and “Line cut detection” as standard.
- The backlit LCD offers enhanced visibility.
- Four types of measurement value can be chosen for display freely from R, X, | Z |, θ , V, and I.
- Equipped with GPIB, RS232C and USB interfaces as standard.
- Impedance measurements can be made in the range of 10 mHz to 10 kHz as well on both primary and secondary cells.