Description
The TFG3200E series DDS function generator is 2 channel digital function generator based on DDS technology.The DDS digital function generator is available with four models:5MHz DDS Function generator10MHz DDS Function generator15MHz Function signal generatorFunction generator 20MHzThe dual channel DDS function generator signal can be used as student function generator, DIY electronic kits function generator.
Features:
★ Max. output frequency 5MHz/10MHz/15MHz/20MHz
★ 2 output channels
★ Direct Digital Synthesis technology (DDS)
★ Sampling rate 100MSa/s, vertical resolution 8 bits, waveform length 1024 points
★ Min. 1mV (50Ω) waveform output with good stability
★ 32 built-in waveforms
★ 40 sets panel setting save & recall
★ Modulations: FM, FSK, ASK, PSK
★ Frequency sweep, amplitude sweep, burst and TTL output functions
★ Over voltage protection, over current protection, short circuit protection, reverse voltage protection
★ Standard parts: 200MHz frequency counter
★ Optional parts: RS-232 interface, power amplifier
Specifications:
Model | TFG-3205E | TFG-3210E | TFG-3215E | TFG-3220E | |
Frequency range | 1μHz~5MHz | 1μHz~10MHz | 1μHz~15MHz | 1μHz~20MHz | |
Waveform (CHA) | |||||
Type | 32 built-in waveforms, including Sine, Square, Triangle, Ramp, Pulse, etc. | ||||
Length | 1024 points | ||||
Vertical resolution | 8 bits | ||||
Sampling rate | 100MSa/s | ||||
Harmonic distortion of sine | ≥40dBc (<1MHz); ≥35dBc (1MHz~20MHz) | ||||
Total distortion of sine | ≤1% (20Hz~200kHz) | ||||
Rise/fall time of square | ≤35ns | ||||
Overshoot of square | ≤10% | ||||
Duty cycle of square | 1%~99% | ||||
Frequency (CHA) | |||||
Range | Sine | 1μHz~5MHz | 1μHz~10MHz | 1μHz~15MHz | 1μHz~20MHz |
Square | 1μHz~5MHz | ||||
Other | 1μHz~1MHz | ||||
Resolution | 1μHz | ||||
Accuracy | ±5×10-5 | ||||
Stability | ±5×10-6/3hours | ||||
Amplitude (CHA) | |||||
Range | 2mVpp~20Vpp, 1μHz~10MHz (high impedance) 2mVpp~15Vpp, 10MHz~15MHz (high impedance) 2mVpp~8Vpp, 15MHz~20MHz (high impedance) | ||||
Resolution | 20mVpp (amplitude>2Vpp); 2mVpp (amplitude<2Vpp) | ||||
Accuracy | ± (1%+2mVrms)(high impedance, RMS, frequency 1kHz) | ||||
Stability | ±0.5% /3hours | ||||
Flatness | ±5% (frequency <10MHz); ±10% (frequency >10MHz) | ||||
Output impedance | 50Ω | ||||
DC Offset (CHA) | |||||
Range | ±10V (high impedance, attenuation 0 dB) | ||||
Resolution | 20mVdc | ||||
Accuracy | ±(1%+20mVdc) | ||||
Sweep (CHA) | |||||
Parameter | Frequency, Amplitude | ||||
Range | Free to set starting point and end point | ||||
Time | 100ms~900s | ||||
Direction | Up, Down, Up-Down | ||||
Mode | Linearity, Logarithmic | ||||
Control | Auto sweep or manual sweep | ||||
Frequency Modulation (FM) (CHA) | |||||
Carrier signal | CHA signal | ||||
Modulating signal | CHB or external signal | ||||
FM deviation | 0%~20% | ||||
Burst (CHA) | |||||
Carrier signal | CHA signal | ||||
Trigger signal | TTL_A signal | ||||
Burst counts | 1~65000 cycles | ||||
Trigger mode | Internal TTL, External, Single | ||||
Shift Keying (CHA) | |||||
FSK | Free to set the hop frequency and the carrier frequency | ||||
ASK | Free to set the hop amplitude and the carrier amplitude | ||||
PSK | Hop phase: 0~360°, resolution: 1° | ||||
Alternative rate | 10ms~60s | ||||
Waveform (CHB) | |||||
Type | 32 built-in waveforms, including Sine, Square, Triangle, Ramp, Pulse, etc. | ||||
Length | 1024 points | ||||
Vertical resolution | 8 bits | ||||
Sampling rate | 12.5MSa/s | ||||
Duty cycle of square | 1%~99% | ||||
Frequency (CHB) | |||||
Range | Sine: 1μHz~1MHz; Other: 1μHz~100kHz | ||||
Resolution | 1μHz | ||||
Accuracy | ±1×10-5 | ||||
Amplitude (CHB) | |||||
Range | 50mVpp~20Vpp (high impedance) | ||||
Resolution | 20mVpp | ||||
Output impedance | 50Ω | ||||
Burst (CHB) | |||||
Carrier signal | CHB signal | ||||
Trigger signal | TTL_B signal | ||||
Burst counts | 1~65000 cycles | ||||
Trigger mode | Internal TTL, External, Single | ||||
TTL output | |||||
Waveform | Square, rise/fall time ≤20ns | ||||
Frequency | 10mHz~1MHz | ||||
Amplitude | TTL, CMOS compatible, low<0.3V, high>4V | ||||
Frequency counter | |||||
Testing frequency range | 1Hz~200MHz | ||||
Input signal amplitude | 100mVpp~20Vpp | ||||
Remote control | RS-232 interface (optional) | ||||
Power amplifier (optional) | |||||
Max. output power | 7W (8Ω), 1W (50Ω) | ||||
Max. output voltage | 22Vpp | ||||
Frequency bandwidth | 1Hz~200kHz | ||||
Common characteristics | |||||
Operation characteristics | Key operation for all functions, Menu display, Rotary dial adjustment | ||||
Display | Mono LCD | ||||
Language | English, Chinese (simplified), Chinese (traditional) | ||||
Power source | AC110V/220V±10% selectable, 50/60Hz, Max. 45VA | ||||
Environmental condition | 0~40℃,<80%RH | ||||
Standard accessories | Power cord x1, Operation manual x1, BNC-BNC cable x1, Test lead x1 | ||||
Dimension | 385x260x110mm | ||||
Weight | 3.5kg |